Lab 5: Nomenclature Puzzle

I.Goal of Activity: The goal of this activity was to practice matching chemical formulas and the names of these formulas.

II. Biggest Challenge: The biggest challenge of this lab was trying to start the puzzle. We had no ideas how to start and because of this we messed up a little at the end. Figuring out where the matches were on the triangles and trying to fit together all the pieces was also very challenging.

III. Biggest Contribution: My biggest contribution to the group was being the connector and bridging all the chunks of pieces together into one square. I also helped my group match the correct triangles by looking up the proper names for them.

IV. The Puzzle: 


                                                           (Finished Puzzle)

Comments

Post a Comment

Popular posts from this blog

Lab 18: Alka Seltzer and the Ideal Gas Law

Image
I. Introduction:   In this lab the purpose was to measure the reaction between Alka Seltzer and water and to  determine the mass of the gas produced. What we did was, first we smashed up an alka seltzer tablet and put it inside a balloon. We then put the balloon over a graduated cylinder full of water and as the two substances combined, CO2 was produced and collected in the balloon. After all the gas had been created we measured the circumference of the balloon. We then emptied the gas and refilled the balloon with water until it had the same circumference. From this we were able to measure the water and find the volume. Through a series of calculations , we were able to conclude that the mass of CO2 was around 1.26 grams in our experiment. II. Data:  III. Calculations:  (Setup) IV: Analysis Questions:  1. Discuss an area in this lab where experimental error may have occurred. There are many instances where an experimental error may have occurred  For exam
Read more

Lab 11: Flame Test Lab

Image
I. Introduction:  The purpose of this lab was to observe how certain atoms react and release energy within different compounds and solutions. We performed the lab by taking samples of the nine compounds and held them over a bunsen burner. Then, we observed any color or texture changes and recorded them. We also had identify two unknown chlorine compounds using flame tests. To identify the two unknowns, we compared their flame colors to those of the other eight compounds and assumed the solution based of this. II. Pre Lab Questions: III. Data:  IV. Analysis Questions:  Picture of LiCl emitting Pink Light:
Read more

Lab 12: Electron Configuration Battleship

Image
I. Picture of My Setup:  II. Biggest Challenge: My biggest challenge playing was trying to do the electron configurations in my head. Also trying to solve the f block configuration in my head was extremely challenging. III. What I Learned: I learned how to solve electron configuration faster and efficiently using the periodic table. 
Read more